Skip to content
Windowsill Harvest

Seedlings Not Coming Up, Leggy, or Falling Over: A Troubleshooting Guide

Why seeds fail to germinate, why seedlings stretch and lean, and what damping off actually looks like — a symptom-first guide to fixing each one.

By The Windowsill Harvest Team Published
A seed tray with some seedlings upright and green and others pale, stretched and leaning sideways

Starting seeds indoors covers the method that works most of the time: depth, warmth, and getting light onto a seedling the moment it shows green. This is what to do when it doesn’t — nothing comes up at all, what does come up stretches and leans, or a seedling that looked fine yesterday is flat on the soil today. All three look like different versions of “it died,” but they have different causes and different fixes, and telling them apart matters more than reacting fast.

The three failures, at a glance

Common seed-starting problems, by what you actually see
What you see Likely cause
Nothing has come up after the expected number of days Wrong depth, wrong temperature, old seed, or a dried-out tray
Thin, pale stems that lean hard toward the light and keep getting taller Legginess — not enough light, too late
Seedlings come up fine, then collapse at the base within a day or two Damping off, a fungal disease
Seedlings upright but uniformly pale yellow-green Still running on seed reserves, or light-starved
Fine white or grey fuzz around the base of stems or on the soil surface Root hairs (harmless) or true mold

Nothing has come up at all

Before assuming the seed is bad, rule out the three things that cause most failed germinations.

Temperature is the most common culprit. Most vegetable and herb seed wants 65–75°F (18–24°C) at the seed itself, not the air a foot above it — a tray on a cold windowsill in winter can sit well below that even in a warm room. Spinach is the one common exception, germinating best on the cooler side of that range and stalling if it gets too warm; see the germination table in the seed-starting guide for specifics by crop.

Depth is the second. Buried too deep, a seed runs out of stored energy before it reaches the surface — this is more often the problem than people expect, especially with dust-fine seed like lettuce or basil pressed in too firmly rather than barely covered. Sown too shallow or left fully exposed, the surface dries out before the seed can take up enough water to start.

A tray that dried out even once during germination can stall completely, even if it looks fine again by the time you check it. A seed that’s started to swell and then dries back out doesn’t simply resume where it left off — it often just fails. This is the main argument for a clear lid or cling film over the tray until the first green shows, holding humidity so a single missed watering doesn’t end the tray.

If you’re not sure the tray ever got genuinely warm enough, a seedling heat mat with a built-in thermostat removes the guesswork — useful for anything started on a cool windowsill in winter, or for warmth-loving seed like peppers that wants closer to 80–85°F to germinate quickly and evenly.

Seedling heat mat with thermostat

Search current listings on Amazon Amazon (opens in a new tab, affiliate link)

Search link, not a specific listing — look for one with a thermostat rather than a mat that just runs at a fixed temperature, which is easy to overheat a small tray with.

Leggy, pale, stretching seedlings

This is a light problem, and it moves faster than most people expect.

How to tell: stems are noticeably thinner than they should be, the gap between leaves is longer than normal, and the whole seedling leans hard toward the brightest thing nearby — a window, a lamp, anything. Left alone, it keeps stretching and the stem thins further, since the plant is putting energy into reaching for light rather than building itself up.

Why it happens: a seedling left in weak or absent light for even two or three extra days after germination stretches toward whatever brightness it can find. This is called etiolation, it starts within days of the first green showing, and the stem that’s already stretched doesn’t thicken back up afterward — you manage it going forward, you don’t reverse it.

Fix: get the tray under real light the moment the first seedling shows green, not once a few more come up. A bright, unobstructed window can be enough for some crops, but a dedicated grow light removes the guesswork, and how close it needs to be matters as much as having one at all — the grow light distance chart covers starting distances by actual wattage, and the clip-on grow light comparison covers what to buy if a window alone isn’t delivering enough. Run it 12–14 hours a day rather than guessing at “daylight hours.”

Damping off: seedlings collapse at the base

This is the one that looks the most alarming, and it’s worth telling apart from legginess, because the cause and the fix are completely different.

How to tell: a seedling that was upright and apparently fine collapses at the soil line within a day or two, as if pinched or water-soaked right at the base. Unlike legginess, which develops gradually over days, this happens fast, and unlike legginess, it isn’t about light at all.

Why it happens: damping off is a fungal disease that thrives in still, overly wet, poorly ventilated conditions — exactly what a humidity dome left on too long after germination creates. The fungus attacks right at the soil line, which is why the stem fails there specifically rather than the seedling simply wilting all over.

Fix: there isn’t one, for a seedling that’s already collapsed — the fix is entirely about the next tray. Remove any humidity dome or cling film the moment the first green shows rather than leaving it on “to be safe.” Don’t overwater, and water from below where the crop allows it, so water reaches the roots without sitting on the surface around the stem. Give the tray some air movement once uncovered — a window cracked open nearby, or a small fan running at a distance, is usually enough. The full seed-starting guide covers this prevention step as part of the method; this section is for recognizing it once it’s already happened, so the next tray doesn’t repeat it.

If only a few seedlings in a tray have collapsed and the rest still look firm at the base, remove the affected ones promptly rather than waiting — damping off spreads tray to tray through the same wet, still conditions that caused it in the first place, and a dense tray of small seedlings has very little space between them for it to spread across.

Yellow or pale seedlings that are otherwise upright

Less urgent than the other two, and often not actually a problem.

How to tell: the seedling stands up fine and the stem looks normal, but the color is a washed-out pale green or yellow-green rather than the deeper green you’d expect, and it isn’t stretching toward anything.

Why it happens: a seedling runs on energy stored in the seed itself for roughly its first one to two weeks, largely independent of feeding, so pale color at this stage is rarely a nutrient problem the way it would be on an older plant — the full breakdown of yellowing on established plants covers that later stage, but it mostly doesn’t apply yet. At the seedling stage, pale color combined with otherwise normal growth is more often just the first true leaves not having fully greened up, which resolves within a few days on its own.

Fix: if it’s genuinely light-starved rather than just newly emerged, it will also start to stretch — treat it as the legginess case above. If color is the only symptom and the seedling isn’t stretching, hold off on feeding until the second set of true leaves is out, then start a quarter-strength liquid feed as the fertilizing guide describes, rather than feeding early to try to fix a color that would likely have resolved on its own.

Fuzz on the surface: mold, root hairs, or just damp mix

Easy to mistake for one another, and worth getting right before deciding whether to discard a tray.

Fine, white, silky fuzz clustered right at the base of each stem, even across the whole tray, is usually root hairs — a normal part of the plant, not a problem. It tends to flatten out or vanish within a day of watering, because it’s structurally soft. Microgreens troubleshooting covers telling this apart from true mold in more detail, since the two get confused constantly and the tray-scale version of this problem shows up there first, usually a few days before a slower-growing herb or vegetable tray would show it.

Patchy grey, bluish, or dark fuzz that spreads rather than staying even, especially with a musty smell, is mold rather than root hairs — the same still, overly wet, poorly ventilated conditions that cause damping off are what let it establish. Treat it the same way: more airflow, less standing moisture on the surface, and the dome off as soon as the first green shows.

When to keep troubleshooting, and when to just resow

Where to go next

This covers what to do when seed-starting goes wrong; the full seed-starting guide is the method for getting it right in the first place, including sowing depth and germination times by crop. If the issue showed up well after germination, on an established plant rather than a seedling, yellow leaves on an indoor plant and common indoor plant pests cover that later stage instead.

Filed under Plant Care. Questions or a correction? Get in touch.

Keep reading